TY  - JOUR
U1  - Zeitschriftenartikel, wissenschaftlich - begutachtet (reviewed)
A1  - Badila, Monica
A1  - Jocham, Christoph
A1  - Zhang, Wenbiao
A1  - Schmidt, Thomas
A1  - Wuzella, Günter
A1  - Müller, Uwe
A1  - Kandelbauer, Andreas
T1  - Powder coating of veneered particle board surfaces by hot pressing
JF  - Progress in organic coatings
N2  - The powder coating of veneered particle boards by the sequence electrostatic powder application -powder curing via hot pressing is studied in order to create high gloss surfaces. To obtain an appealingaspect, veneer Sheets were glued by heat and pressure on top of particle boards and the resulting surfaceswere used as carrier substrates for powder coat finishing. Prior to the powder coating, the veneeredparticle board surfaces were pre-treated by sanding to obtain good uniformity and the boards werestored in a climate chamber at controlled temperature and humidity conditions to adjust an appropriate electrical surface resistance. Characterization of surface texture was done by 3D microscopy. The surfaceelectrical resistance was measured for the six veneers before and after their application on the particleboard surface. A transparent powder top-coat was applied electrostatically onto the veneered particleboard surface. Curing of the powder was done using a heated press at 130◦C for 8 min and a smooth, glossy coating was obtained on the veneered surfaces. By applying different amounts of powder thecoating thickness could be varied and the optimum amount of powder was determined for each veneer type.
KW  - powder coating
KW  - veneer
KW  - particle board
KW  - curing
KW  - gloss
Y1  - 2014
SN  - 0300-9440
SS  - 0300-9440
U6  - https://doi.org/10.1016/j.porgcoat.2013.09.018
DO  - https://doi.org/10.1016/j.porgcoat.2013.09.018
VL  - 77
IS  - 10
SP  - 1547
EP  - 1553
S1  - 7
PB  - Elsevier
CY  - Amsterdam
ER  -