TY  - CHAP
U1  - Konferenzveröffentlichung
A1  - Beyer, Richard
A1  - Freere, Peter
A1  - van Niekerk, Theo
A1  - Sönmez, Ertuğrul
T1  - Design of a universal charger for a light electric vehicle with effect of an RCD snubber on peak current control
T2  - 2020 International Conference on Electrical Engineering and Control Technologies (CEECT), 10-13 December 2020, Melbourne, Australia, proceedings
N2  - The design process for a single phase, smart, universal charger for light electric vehicles, is presented. With a step up, power factor correction circuit, followed by a phase shifted, full bridge converter, with synchronous rectification on the secondary side. Due to the resistor-capacitor-diode snubber on the secondary side, the current peak at the start of power transfer, leads to false triggering during light load control with peak current mode control. The solution developed for light loads, is to change from peak current control to voltage control. This is achieved by limiting the maximum phase shift, instead of changing the reference value. For the power factor correction stage, measured and calculated efficiencies are compared as a function of the output power. The voltage and current waveforms are shown for the power factor correction circuit, and for the phase shifted bridge, the measured current waveform is compared with simulation.
KW  - charger
KW  - LEV light electric vehicle
KW  - snubber
KW  - PCMC
Y1  - 2020
U6  - https://doi.org/10.1109/CEECT50755.2020.9298611
DO  - https://doi.org/10.1109/CEECT50755.2020.9298611
SP  - 9
EP  - 13
S1  - 5
PB  - IEEE
CY  - Piscataway, NJ
ER  -