Refine
Year of publication
- 2017 (4) (remove)
Document Type
- Journal article (2)
- Conference proceeding (2)
Language
- English (4)
Has full text
- yes (4)
Is part of the Bibliography
- yes (4)
Institute
- Technik (4)
Publisher
- IEEE (2)
- American Chemical Society (1)
- EMW (1)
This work presents a spiral antenna array, which can be used in the V- and W-Band. An array equipped with Dolph-Chebychev coefficients is investigated to address issues related to the low gain and side lobe level of the radiating structure. The challenges encountered in this achievement are to provide an antenna that is not only good matched but also presents an appreciable effective bandwidth at the frequency bands of interest. Its radiation properties including the effective bandwidth and the gain are analyzed for the W-Band.
We present a topology of MIMO arrays of inductive antennas exhibiting inherent high crosstalk cancellation capabilities. A single layer PCB is etched into a 3-channels array of emitting/receiving antennas. Once coupled with another similar 3-channels emitter/receiver, we measured an Adjacent Channel Rejection Ratio (ACRR) as high as 70 dB from 150 Hz to 150 kHz. Another primitive device made out of copper wires wound around PVC tubes to form a 2-channels “non-contact slip-ring” exhibited 22 dB to 47 dB of ACRR up to 15MHz. In this paper we introduce the underlying theoretical model behind the crosstalk suppression capabilities of those so-called “Pie-Chart antennas”: an extension of the mutual inductance compensation method to higher number of channels using symmetries. We detail the simple iterative building process of those antennas, illustrate it with numerical analysis and evaluate there effectiveness via real experiments on the 3-channels PCB array and the 2-channels rotary array up to the limit of our test setup. The Pie Chart design is primarily intended as an alternative solution to costly electronic filters or cumbersome EM shields in wireless AND wired applications, but not exclusively.
Energy transfer kinetics in photosynthesis as an inspiration for improving organic solar cells
(2017)
Clues to designing highly efficient organic solar cells may lie in understanding the architecture of light harvesting systems and exciton energy transfer (EET) processes in very efficient photosynthetic organisms. Here, we compare the kinetics of excitation energy tunnelling from the intact phycobilisome (PBS) light harvesting antenna system to the reaction center in photosystem II in intact cells of the cyanobacterium Acaryochloris marina with the charge transfer after conversion of photons into photocurrent in vertically aligned carbon nanotube (va- CNT) organic solar cells with poly(3-hexyl)thiophene (P3HT) as the pigment. We find that the kinetics in electron hole creation following excitation at 600 nm in both PBS and va-CNT solar cells to be 450 and 500 fs, respectively. The EET process has a 3 and 14 ps pathway in the PBS, while in va-CNT solar cell devices, the charge trapping in the CNT takes 11 and 258 ps. We show that the main hindrance to efficiency of va CNT organic solar cells is the slow migration of the charges after exciton formation.
This paper reports an analysis of application and impact of FMEA on susceptibility of generic IT-networks. It is not new that in communication system, the frequency and the data transmission rate play a very important role. The rapid increase in miniaturization of electronic devices leads to very sensitivity against electromagnetic interference. Since the IT network with the data transfer rate makes a huge contribution to this development it is very important to monitor their functionality. Therefore, tests are performed to observe and ensure the data transfer rate of IT networks against IEMI. A fault tree model is presented and observed effects during radiation of disturbance on complex system by a HPEM interference sources are described using a continuous and consistent model of the physical layer to the application layer.